About FAQ Contact Call (808) 219-0537
Frigidaire ice

Frigidaire ice maker repair on Oahu

Plastic in the ice is a recall question first. In 2024 CPSC listed about 383,240 Frigidaire side-by-sides built 2015 to 2019 whose Slim Ice bucket part could break off into the cubes.

Automatic ice maker fixed inside a freezer with cubes collected in the bin below

Frigidaire ice in four figures

3.2-3.7 lb
a day, French door model
1.5-2 lb
a day, top-freezer kit
30-100 psi
cold water supply
383,240
side-by-sides, 2024 bucket recall

Sources: Frigidaire refrigerator and top-freezer use and care guides; CPSC recall notices (2022 ice level arm, 2024 Slim Ice bucket)

Reading the ice

What is your Frigidaire ice telling you?

What you seeWhat Frigidaire's guide points toFirst move
Small cubes, again and againLow water pressure or a water filter near the end of its lifeChange the filter; if it persists, test the supply
Hollow shells glued together in the binThe ice maker is not getting enough waterTechnician, once the line and valve are ruled in
Loud chatter from the backIce maker left on with no water connectedSwitch the ice maker off until a line is run
Cubes fused into one blockIce sitting unused for daysUse ice at least twice a week
Dispenser quits mid-pourPaddle held too long, so the motor overload trippedWait about three minutes for it to reset
Weak flow on a reverse osmosis linePressure under 20 psi while the RO unit regenerates is normalRecheck after the RO tank refills
New install or new line

How should a Frigidaire ice maker start up?

1

Right line

Run cold water through 1/4 inch OD copper or braided stainless. Frigidaire warns off plastic tubing and self-piercing saddle valves.

2

Prime it

Hold a glass at the dispenser until water flows, about 1 1/2 minutes, then keep it running roughly four more minutes.

3

Give it a day

Little or no ice in the first 24 hours is expected. Trapped air can cause two or three empty cycles.

4

Dump batch one

The first cubes can look off-color or taste odd. Throw them out before you call anything a fault.

A part that breaks

The Frigidaire ice level arm and its recall

The plastic signal arm stops ice production when the bin is full. Frigidaire says it is not an off switch. On some 2020 to 2022 units the arm itself was the problem. In June 2022 CPSC announced about 367,500 refrigerators, 13 Frigidaire models and one Electrolux, sold April 2020 to March 2022, whose ice level arm could snap into the bucket. There were 185 reports. Check the label on the right interior wall of the fresh food section before paying for a new arm.

Island water

Does Oahu water hurt a Frigidaire ice maker?

Rarely the water itself. Oahu's public supply has historically tested soft to moderately hard, according to an older USGS summary. Frigidaire's warning is about equipment: a water softener that is not working properly can release chemicals that harm the ice maker. The usual culprit here is the line: a kinked plastic tube behind a fridge in a tight condo kitchen starves the valve.

Copper or braided line No saddle valves Softener kept serviced Filter every six months
Refrigerator standing open with food on its shelves and bottles in the door bins
01

Output and start-up

About 3.2 to 3.7 lb per 24 hours on a recent French door model.
On many top-freezer models, yes. Frigidaire sells the ice maker as an optional kit, IMKTF20A, that can go in later. The guide rates it at 1.5 to 2 lb a day, about 10 cubes every 100 to 160 minutes.
New lines can give the first cubes an odd color or taste, so discard the early batches.
On the dual ice maker model, Fast Freeze raises output for a while. Each of the two ice makers is rated at about 2.5 lb a day.
Turn the ice maker off at its own control. It ships switched on, and running it dry makes the fill valve chatter; the signal arm only pauses production when the bin is full.
02

Parts, recalls and water

Side-by-sides built 2015 to 2019 with Slim Ice buckets, such as FGSS2635TF and FFSC2323TS. CPSC counted 343 reports of the bucket part breaking and sending plastic out with the ice.
Yes, Frigidaire says a softener that is not working properly can harm it.
For short spells, yes. Frigidaire treats pressure under 20 psi as normal during the RO regeneration phase, so slow fills at that time are expected.
The ice maker is part of the refrigerator, and the guides give one year of parts and labor on defects, paid by Electrolux. Keep the receipt with the model and serial. On Oahu a covered module or valve often still has to ship from the mainland, so plan on some waiting even when the cost is covered.
Ice that sits unused fuses in the bin. Frigidaire suggests using ice at least twice a week to keep cubes separate. Thin hollow shells are different: that ice maker is short on water.

Frigidaire ice maker gone quiet?

Talk to a person
(808) 219-0537
Call Now →
Sun through Thu 6am-12am | Fri 6am-3:30pm
Call (808) 219-0537